RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
6. Place suction tube in oil pan and guide them into place. Using a new tube-to-block gasket, install the suction tube bolts. Tighten the bolts to 24 Nm
(18 ft. lbs.). Tighten the remaining tube brace bolts to 43 Nm (32 ft. lbs.).
7. Starting in the center and working outward, tighten the oil pan bolts to 28 Nm (21 ft. lbs.).
8. Install the steering rack bolts. Tighten bolts to 251 Nm (185 ft. lbs.).
9. Install the flex plate. Tighten bolts to 137 Nm (101 ft. lbs.).
10. Install the flywheel to crankshaft adapter. Tighten to 137 Nm (101 ft. lbs.).
11. Install the flywheel housing assembly with the starter motor attached and tighten bolts to 77 Nm (57 ft. lbs.).
12. Install transmissionSee: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/Installation
NOTE: Make sure that the fan shroud seal is properly seated in the radiator fan shroud and that it is not out of position causing excessive
contact with the radiator coolant tubes.
13. Install the fan and fan shroud See: Cooling System/Radiator Cooling Fan/Service and Repair/Electric Radiator Fan - Installation
14. Install the starter See: Starting and Charging/Starting System/Starter Motor/Service and Repair/Starter - Installation
