RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
NOTE: If this flash process is interrupted or aborted, the flash should be restarted.
6. Continue to complete the process if the ECU has been replaced.
7. Type the necessary information on the "Authorized Modification Label" (p/n 04275086AB) and attach near the VECI label (See Section 3
SECTION 3 - AUTHORIZED MODIFICATION LABEL for details).
REPAIR PROCEDURE - wiTECH(TM) Diagnostic Application
NOTE: If this flash process is interrupted or aborted, the flash should be restarted.
1. Open the hood of the vehicle and install a battery charger. Verify that the charging rate provides a continuous charge of 13.2 - 13.5 Volts.
2. Connect the wiTECH(TM) Vehicle Connection Interface (VCI) pod to the vehicle data link connector located under the steering column and turn
the ignition key to the "RUN" position.
3. Launch the wiTECH(TM) Diagnostic Application and connect to the appropriate wiTECH(TM) device.
4. From the wiTECH(TM) Diagnostic Application Home screen,
a. Select "HELP"
b. Select "HELP CONTENTS"
c. Follow the "HELP TOPIC" for flashing an ECU.
SECTION 2 - ADDITIONAL PCM/ECM / TCM REPLACEMENT PROCEDURES
NOTE: Find the PCM/ECM /TCM Type for the vehicle, read and write down the steps, and then go to the step by step instructions for
additional information on how to perform these procedures. STEP-BY-STEP INSTRUCTIONS
If an 2.0L Controller was replaced, perform the following additional steps and/or routines:
1. PCM/ECM Replaced - if WCM equipped
2. Check PCM/ECM VIN - if NOT WCM equipped
3. Program Variant Code
If a PT Cruiser, 2.2L Controller was replaced, perform the following additional steps and/or routines:
1. PCM/ECM Replaced - if WCM equipped
2. Check PCM/ECM VIN - if NOT WCM / SKREEM equipped
3. IMA Rapid Calibration Test - Only on 06 PT AND up
4. Injector Quantity Adjustment - Only on 06 PT AND up
If a 3.0L Controller was replaced, perform the following additional steps and/or routines:
1. PCM/ECM Replaced - if WCM equipped
2. Check PCM/ECM VIN - if NOT WCM equipped
3. Diesel Particulate Filter (Used) Learning
4. NOx Catalyst (New) Initialization
5. Injector Quantity Adjustment
6. IMA Rapid Calibration Test
7. Fuel Mean Value Adaptation Initialization
8. Exhaust Throttle Plate Adaptive Learn Position
If a 2.8L Controller was replaced, perform the following additional steps and/or routines:
1. PCM/ECM Replaced - if WCM equipped
2. Check PCM/ECM VIN - if NOT WCM equipped
3. Injector Quantity Adjustment
4. Program Variant Code
5. ECU Replacement With Value Transfer - if the ECU to be replaced is still responsive
6. ECU Replacement Without Value Transfer - if the ECU to be replaced is NOT responsive
7. Fuel Mean Value Adaptation Initialization
8. IMA Rapid Calibration Test
9. Set Oil Dilution Mass Value
If a PM/MK, 2.2L Controller was replaced, perform the following additional steps and/or routines:
1. PCM/ECM Replaced - if WCM equipped
2. Check PCM/ECM VIN - if NOT WCM / SKREEM equipped
3. Program Variant Code