RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
EGR CROSSOVER TUBE
11. Clean each end of EGR crossover tube and its connection points of any old gasket material
12. Install new gaskets to each end of the EGR crossover tube (2).
13. Position EGR crossover tube (2) to engine.
14. Install bolt (5) finger tight at center bottom of the EGR crossover tube.
15. First, tighten EGR tube clamp (1) to 10 Nm (89 in. lbs.), then tighten clamp (3) to 10 Nm (89 in. lbs.).
16. Tighten EGR crossover tube bolt (5) to 10 Nm (89 in. lbs.).
17. Connect the EGR temperature sensor harness connector (4).
EGR CROSSOVER TUBE COVER
18. Install the EGR crossover tube cover (2). Tighten bolts (1) to 10 Nm (89 in. lbs.).
19. Connect and both negative battery cables.
