RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
14. Remove the necessary rocker housing mounting bolt.
CAUTION: Fuel Injector Removal/Installer 9010A is equipped with 2 clamshell clamps, a sliding retainer sleeve to retain the clamshell clamps,
a 2-piece mounting stud and a pivoting handle. Do not attempt to remove the fuel injectors with any other device. Damage to
injector will occur.
15. Install and tighten 2-piece mounting stud (3) of Fuel Injector Removal/Installer 9010A, to rocker housing (4). If removing the No. 6 fuel injector,
separate the 2-piece mounting stud (3). Install lower half of mounting stud (3) to center of rocker housing bridge (4) and upper half of mounting
stud to lower half.
16. Position tool handle (2) to mounting stud (3) and install handle nut (1). Leave handle nut (1) loose to allow a pivoting action.
17. Position lower part of clamshell halves (5) to sides of fuel injector (6) (wider shoulder to bottom). The upper part of clamshell halves should also
be positioned into machined shoulder on the handles (2) pivoting head.
18. Slide the retainer sleeve (7) over pivoting handle head (2) to lock clamshell halves (5) together. Be sure handle pivot nut (1) is loose.
19. Depress handle of Fuel Injector Removal/Installer 9010A (2) downward to remove fuel injector straight up from cylinder head bore.
NOTE: If the fuel injectors are being removed such as for engine teardown or diagnostic purposes, be sure to mark each injector with its
corresponding cylinder number. The fuel injectors MUST be reinstalled into the original (same) cylinder due to the fuel injector
correction code.
20. Remove and discard injector sealing washer (2). This washer should be located on tip of injector (1), or may have remained in the injector bore.
