RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
Accelerator Pedal Position Sensor: Service and Repair
Installation
INSTALLATION
CAUTION: Do not attempt to separate or remove the Accelerator Pedal Position Sensor (APPS) from the accelerator pedal assembly. The
APPS and the accelerator pedal is replaced as an assembly. If the sensor is removed from the pedal, the electronic calibration may
be destroyed.
1. Position pedal and APPS assembly to its mounting bracket.
2. Connect 6-way electrical connector to top of APPS (2).
3. Install APPS lower mounting bolt (4) and two mounting nuts.
4. If necessary, use a Scan Tool to erase any Diagnostic Trouble Codes (DTC's).