RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
the upper (two o'clock or ten o'clock) access holes (3) of the steering wheel hub rear trim cover (2), being certain to place the blade of the tool on
the inboard (steering wheel hub) side of the airbag snap retainer wire loop.
6. Push the handle of the tool downward for the blade to pry the snap retainer wire loop (3) upward far enough to disengage the loop from the hook
of the steering wheel armature. At the same time, gently pull the driver airbag (1) away from the steering wheel (2) to prevent the retainer from
snapping back into place over the hook once it is disengaged.
7. Repeat Steps 5 and 6 at the other upper (two o'clock or ten o'clock) access hole to disengage the other upper snap retainer wire loop.
8. Repeat Steps 5 and 6 at the lower (six o'clock) access hole to disengage the lower snap retainer wire loop. The lower snap retainer wire loop has a
distinctive V-shape and must always be installed onto the six o'clock hook of the steering wheel armature.
9. Pull the driver airbag away from the steering wheel far enough to access and disengage the plastic push-in retainer (2) of the clockspring pigtail
wire harness (1) from the locator hole (3) at the 12 o'clock position on the back of the airbag housing.
CAUTION: Do not pull on the clockspring pigtail wires or pry on the connector insulator to disengage the connector from the driver airbag
inflator connector receptacle. Improper removal of these pigtail wires and their connector insulators can result in damage to the
airbag circuits or connector insulators.
