RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
NOTE: Be certain that the gasket between the pressure-type side impact sensor and the front door module carrier panel is in good condition
and positioned on the back of the sensor. There MUST be a good seal between the sensor and the module carrier panel for the sensor
to operate properly. If the gasket is in poor condition, replace the sensor.
1. Position the side impact sensor (1) to the right or left front door module carrier panel (2). When the sensor is correctly positioned, the arrow on the
sensor label will be pointed toward the bottom of the door.
2. Install and tighten the two screws (4) that secure the sensor to the carrier panel. Tighten the screws securely.
3. Reconnect the front door module wire harness connector (3) to the sensor connector receptacle.
4. Reinstall the trim panel onto the inside of the right or left front door. See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door
Panel/Service and Repair/Front Door Trim Panel - Installation.
5. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Service and Repair.
B-PILLAR - STANDARD CAB
1. Position the side impact sensor (2) to the inside of B-pillar. Be certain that the anti-rotation pin on the back of the sensor is engaged in the
clearance hole of the B-pillar.
2. Install and tighten the screw (3) that secures the sensor to the inner B-pillar. Tighten the screw to 9 Nm (80 in. lbs.).
3. Reconnect the body wire harness connector (1) to the sensor connector receptacle.
4. Reinstall the trim onto the inside of the lower B-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim Panel - Installation.
5. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Service and Repair.
B-PILLAR - EXCEPT STANDARD CAB
