RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
Seat Belt Height Adjuster: Service and Repair
Seat Belt Turning Loop Adjuster - Installation
INSTALLATION
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
1. Position the front seat belt turning loop height adjuster (3) horizontally to the inside of the upper B-pillar (1) with the top of the adjuster oriented
rearward.
2. Engage the T-tab (5) near the lower end of the height adjuster into the hole in the B-pillar.
3. Rotate the top of the height adjuster up and forward to a vertical position on the inside of the B-pillar.
4. Lift the height adjuster upward on the B-pillar far enough to engage the hook (4) on the back of the adjuster into the B-pillar clearance hole.
5. Install and tighten the screw (2) that secures the height adjuster to the inside of the upper B-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
6. Reinstall the upper trim onto the inside of the B-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim Panel - Installation.
7. Position the front seat belt (3) turning loop onto the height adjuster (1) on the inside of the upper B-pillar.
8. Install and tighten the screw (4) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. lbs.).
