RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
NOTE: Some vehicles are equipped with the hood ajar switch integrated into the hood latch assembly. This type of hood ajar switch is not
serviced separately and the hood latch assembly must be replaced.See: Body and Frame/Doors, Hood and Trunk/Hood/Hood
Latch/Service and Repair/Hood Latch - Installation
1. Position the hood ajar switch (4) near the mounting bracket (3) on the upper radiator cross member (1).
2. Route the jumper wire harness connector through the switch mounting bracket and reconnect it to the switch.
3. From the top of the mounting bracket, press the switch downward into the mounting hole until the integral switch latch tabs lock it into place.
4. Install the upper radiator seal and push pin retainers.
5. Reconnect the battery negative cable.
6. Close and latch the hood.
