RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
Seat Heater Switch: Service and Repair
Heated Seat Switch - Removal
Rear
REAR
1. Disconnect and isolate the battery negative cable.
2. Using a trim stick (special tool # C-4755) or equivalent, gently pry the upper edge of the floor console rear trim panel (1) to release the retaining
clips at all of the locations around the floor console rear trim panel (3).
3. Lift up and rearward to release the panel lower tabs (2) from the floor console.
4. If equipped, disconnect the 2nd row heated seat switches (1), 115 Volt power outlet (3) and the auxiliary audio jacks (2) electrical connectors from
the floor console rear trim panel.
5. Using a trim stick (special tool # C-4755) or equivalent, gently pry the 2nd row heated seat switch assembly out of the trim panel.
Front
FRONT
