RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
10. Separate the upper ball joint (4) from the knuckle (6) using Ball Joint Remover 9360 (5).
11. Remove the knuckle from the vehicle.
12. Remove the lower stabilizer link nut.
13. Remove the lower ball joint nut at the steering knuckle (1).
14. Separate the ball joint from the knuckle using Ball Joint Remover 8677 (2).
NOTE: Do not allow the upper control arm to rebound downward, it must be supported.
15. Remove the lower control arm support.
16. Tighten the spring compressor tool to allow clearance for the lower ball joint to be removed out of the knuckle.
