RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
Suspension Strut / Shock Absorber: Service and Repair
Independent Front Suspension
Removal
4X2
1. Raise and support vehicle.
2. Support the lower control arm outboard end.
3. Remove the upper shock absorber nut by using Strut Nut Wrench 9362 (1), retainer and grommet (2). If necessary, insert 11/32 socket though
Wrench onto hex located on end of shock shaft to prevent shaft from turning.
4. Remove the lower bolts and remove the shock absorber.
Installation
4X2
NOTE: Upper shock nut must be replaced or use Mopar Lock 'N Seal or Loctite(R) 242 on existing nut.
1. Install the lower retainer and grommet on the shock absorber stud. Insert the shock absorber through the frame bracket hole.
2. Install the lower bolts and tighten the bolts to 26 Nm (19 ft. lbs.).
3. Install the upper grommet, retainer (2) and new nut or use Mopar Lock 'N Seal or Loctite(R) 242 on existing nut, on the shock absorber stud.
Tighten nut to 54 Nm (40 ft. lbs.). using Strut Nut Wrench 9362 (1).
4. Remove the support from the lower control arm outboard end.
5. Remove the support and lower the vehicle.
