RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
Wiper Motor: Service and Repair
Wiper Motor - Removal
REMOVAL
1. Unlatch and open the hood.
2. Remove both wiper arms from the wiper pivots. See: Wiper Arm/Service and Repair/Wiper Arm - Removal.
3. Disconnect and isolate the battery negative cable.
4. Remove the cowl plenum cover/grille panel from over the cowl plenum. See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and
Repair/Cowl Panel Cover - Removal.
5. Disconnect the left headlamp and dash wire harness connector (4) from the wiper motor (6) pigtail wire connector.
6. Remove the nut (5) that secures the crank arm (3) to the wiper motor output shaft.
7. Remove the three screws (1) that secure the wiper motor to the center bracket of the wiper linkage module.
8. Remove the wiper motor from under the wiper linkage module bracket and out of the cowl plenum.
