RAM 3500 Truck 2WD V10-8.0L VIN W (1997)
Combination Valve: Testing and Inspection
METERING VALVE
Metering valve operation can be checked visually with the aid of a helper. Observe the metering valve stem while a helper applies and releases the
brakes. If the valve is operating correctly, the stem will extend slightly when the brakes are applied and retract when the brakes are released. If the
valve is faulty, replace the entire combination valve as an assembly.
PRESSURE DIFFERENTIAL SWITCH
1. Have helper sit in drivers seat to apply brake pedal and observe red brake warning light.
2. Raise vehicle on hoist.
3. Connect bleed hose to a rear wheel cylinder and immerse hose end in container partially filled with brake fluid.
4. Have helper press and hold brake pedal to floor and observe warning light.
a. If warning light illuminates, switch is operating correctly.
b. If light fails to illuminate, check circuit fuse, bulb, and wiring. The parking brake switch can be used to aid in identifying whether or not the
brake light bulb and fuse is functional. Repair or replace parts as necessary and test differential pressure switch operation again.
5. If warning light still does not illuminate, switch is faulty. Replace combination valve assembly, bleed brake system and verify proper switch and
valve operation.
