RAM 3500 Truck 2WD V10-8.0L VIN W (1997)
Water Pump: Service and Repair
Installation
1. If water pump is being replaced, install the heater hose fitting to the pump. Tighten fitting to 16 Nm (144 inch lbs.) torque. After fitting has been
torqued, position fitting as shown. When positioning fitting, do not back off (rotate counterclockwise). Use a sealant on the fitting such as Mopar
(R) Thread Sealant With Teflon. Refer to the directions on the package.
CAUTION: This heater hose fitting must be installed to pump before pump is installed to engine.
2. Clean the o-ring mating surfaces at rear of water pump and front of timing chain/case cover.
3. Apply a small amount of petroleum jelly to o-ring. This will help retain o-ring to water pump.
