dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

All Technical Service Bulletins for Evaporative Emission Control Canister:|141096 > < MIL ON, DTC $71 Set|Page 3296
Page 1
background image

Evaporative Emission Control Canister: All Technical Service Bulletins
EVAP Canister - Fuel Odor/Fuel Discharge

NO: 25-03-97

GROUP: Emissions

DATE: Oct. 17, 1997

SUBJECT:
Fuel Odor And/Or Fuel Discharging From The Evaporative Emissions Canister

MODELS: 
1994 - 1997 (BR) Ram Trucks
 
NOTE

THIS BULLETIN APPLIES TO VEHICLES WITH GASOLINE ENGINES BUILT PRIOR TO DECEMBER 1, 1996 (MDH 1201XX).

SYMPTOM/CONDITION:

Fuel odor coming from under the vehicle and/or a small amount of fuel discharged on the ground underneath the evaporative emissions canister.

A condition may occur where liquid fuel enters the evaporative emissions canister on subject model vehicles. This condition occurs only after the fuel
tank has been completely filled and the vehicle is allowed to set in warm ambient conditions and/or parked on an incline.

DIAGNOSIS:

1.

Raise the vehicle on a lift.

2.

Disconnect all lines to the evaporative emissions vapor canister and remove the vapor canister.

3.

Turn the canister so that the drain hole is pointing down.

4.

If fuel is present, perform the following Repair Procedure. If there is no evidence of fuel, visually inspect for damaged or disconnected vapor lines.

PARTS REQUIRED:

1

52127666

Rollover Valve

1

04723550

Canister, Vapor Carbon, 1994 - 1995 Vehicles

1

53031752AA

Canister, Vapor Carbon, 1996 - 1997 Vehicles

REPAIR PROCEDURE:

This bulletin involves installing a new rollover valve and new evaporative emissions vapor carbon canister.

1.

Install the new evaporative emissions vapor carbon canister (see the Parts Required section) to its bracket. Rotate the canister until the line fittings
are in a horizontal position. Tighten the vapor carbon canister bracket bolt to 10 Nm (95 in. lbs.).

2.

Connect the evaporative system vapor lines to the vapor canister.

3.

Disconnect the vapor line from the vehicle fuel tank rollover valve and remove the rollover valve.

4.

Install vehicle rollover valve, p/n 52127666, onto the fuel tank.

5.

Connect the evaporative system vapor line to the rollover valve.

6.

Lower the vehicle.

POLICY: Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:

Labor Operation No:

25-01-15-94

1.3 Hrs.

FAILURE CODE: P8 - New Part

All Technical Service Bulletins for Evaporative Emission Control Canister:|141096 > < MIL ON, DTC $71 Set|Page 3296