RAM 3500 Truck 2WD V10-8.0L VIN W (1997)
NOTE: Do not remove the tape that secures the sensor wire harness to the connector.
12. To install, plug in the sensor wire harness connector to the impact sensor.
13. Mount the sensor (arrow pointed forward) using the three screws provided with the new sensor. Tighten the screws to 5 to 6 N.m (45 to 55 in.
lbs.).
14. Plug the wire harness connector into the speed control servo.
15. Install the battery tray. Tighten all of the battery tray mounting hardware to 16 N.m (140 in. lbs.).
16. Install the battery in the vehicle, making sure that the battery is properly positioned in the battery tray
17. If equipped, install the battery heat shield.
18. Install the battery holddown clamp. Be certain that the holddown is properly positioned on the battery. Tighten the holddown bolts to 4 N.m (35
in. lbs.).
19. Do not connect the battery negative cable at this time. See Testing and Inspection/Procedures for the proper procedures.
