RAM 3500 Truck 2WD V10-8.0L VIN W (1997)
6. Connect the single wire connector from the overlay harness to the ground terminal on the headlamp switch assembly.
Fig. 4
7. Tuck the relay pack into the instrument panel pocket on the left side between the demister duct and the HVAC duct and then install the
headlamp switch into the instrument panel. Tighten the three attaching screws securely.
8. Connect the lighter wiring connector.
9. Connect the auxiliary power outlet wiring connector to the power outlet on the cluster bezel.
Fig. 3
10. Install the cluster bezel and engage the cluster bezel snap-clip retainers to the instrument panel.
Fig. 2
11. Install the ash receiver bracket. Tighten the bracket screws securely.
12. Install the ash receiver.
