RAM 3500 Truck 2WD V10-8.0L VIN W (1997)
PARTS REQUIRED:
NOTE:
TRANSFER CASES BUILT PRIOR TO MAY 6, 1996 HAVE AN OUTPUT SHAFT THAT IS 1.33 IN. IN DIAMETER WITH 32 SPLINES.
TRANSFER CASES BUILT AFTER MAY 5, 1996 HAVE AN OUTPUT SHAFT THAT IS 1.55 IN. IN DIAMETER WITH 31 SPLINES.
REPAIR PROCEDURE:
This bulletin involves installing a revised clutch disc and propshaft.
1.
Using the procedures outlined in the appropriate service manual, install revised clutch disc p/n 52107666 and the appropriate revised propshaft
specified in the Parts Required section of this bulletin.
NOTE:
DO NOT REUSE THE ORIGINAL REAR U-JOINT BOLTS OR STRAPS.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
06-20-01-97
Clutch Disc Replace
2.6 Hrs.
Optional Equipment:
06-20-01-63
Equipped with 4WD
0.8 Hrs.
**06-20-01-60
Equipped With A Skid
0.2 Hrs.**
Plate
FAILURE CODE: P8 - New Part