RAM 3500 Truck 2WD V10-8.0L VIN W HDC (2000)
Engine Coolant Temperature (ECT) Sensor: Service and Repair
REMOVAL
WARNING: HOT, PRESSURIZED COOLANT CAN CAUSE INJURY BY SCALDING. COOLING SYSTEM MUST BE PARTIALLY
DRAINED BEFORE REMOVING THE COOLANT TEMPERATURE SENSOR.
1. Partially drain cooling system.
Fig. 50 Engine Coolant Temperature Sensor
2. Disconnect electrical connector from sensor.
3. Remove sensor from intake manifold.
INSTALLATION
1. Install sensor.
2. Tighten to 6-8 Nm (55-75 in. lbs.) torque.
3. Connect electrical connector to sensor.
4. Replace any lost engine coolant.
