RAM 3500 Truck 2WD V10-8.0L VIN W HDC (2000)
Throttle Position Sensor: Service and Repair
Fig. 33 TPS Mounting Bolts
REMOVAL
The TPS is located on the side of the throttle body.
1. Remove air intake tube at air cleaner housing.
2. Remove the air cleaner cover.
3. Remove the 4 air cleaner housing mounting nuts and remove housing from throttle body.
4. Disconnect TPS electrical connector.
5. Remove two TPS mounting bolts.
6. Remove TPS from throttle body.
Fig. 34 Installation - Typical Mounting
INSTALLATION
The throttle shaft end of the throttle body slides into a socket in the TPS. The TPS must be installed so that it can be rotated a few degrees. If the
