RAM 3500 Truck 2WD V10-8.0L VIN W HDC (2000)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor Location
The Crankshaft Position Sensor is located on the right-lower side of the cylinder block, forward of the right engine mount, just above the oil pan rail.
REMOVAL
1. Raise and support vehicle.
2. Disconnect sensor pigtail harness from main engine wiring harness.
Sensor Remove/Installation
3. Remove sensor mounting bolt.
4. Cut plastic tie strap securing sensor pigtail harness to side of engine block.
5. Carefully pry sensor from cylinder block in a rocking action with two small screwdrivers.
6. Remove sensor from vehicle.
