RAM 3500 Truck 2WD V10-8.0L VIN W MDC (1999)
Servo Cable Clip Remove/Install - Typical
11. Position battery tray with attached servo assembly to gain access to 2 servo mounting nuts.
12. Remove 2 mounting nuts holding servo cable sleeve to bracket.
13. Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip and remove clip. Note: The servo
mounting bracket displayed is a typical bracket and may/may not be applicable to this model vehicle.
14. Remove servo from mounting bracket. while removing, note orientation of servo to bracket.
INSTALLATION
1. Position servo to mounting bracket.
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
3. Insert servo studs through holes in servo mounting bracket.
4. Insert servo studs through holes in servo cable sleeve.
5. Install servo mounting nuts and tighten to 8.5 N.m (75 in lbs) torque.
6. Connect vacuum line to servo.
7. Connect electrical connector to servo terminals.
8. Connect servo cable to throttle body. Refer to Servo Cable Replacement.
9. Install battery tray. Tighten all battery tray mounting hardware to 16 N.m (140 in lbs) torque.
10. Position battery into battery tray.
11. If equipped, install battery heat shield.
12. Install battery holddown clamp. Tighten bolt to 4 N.m (35 in lbs) torque.
13. Connect positive battery cable to battery.
14. Connect negative battery cable to battery.
15. Before starting engine, operate accelerator pedal to check for any binding.