RAM 3500 Truck 2WD V10-8.0L VIN W MDC (1999)
Injector Retaining Clips - Typical Injector
12. Remove the clip(s) retaining the injector(s) to fuel rail.
INSTALLATION
1. Apply a small amount of engine oil to each fuel injector O-ring. This will help in fuel rail installation.
2. Install injector(s) and injector clip(s) to fuel rail.
NOTE: The fuel injector electrical connectors on all 10 injectors should be lacing to the right (passenger) side of the vehicle.
4. Position the fuel rail/fuel injector assembly to the injector openings on the intake manifold.
5. Guide each injector into the intake manifold. Be careful not to tear the injector O-ring.
6. Push the right fuel rail down until fuel injectors have bottomed on injector shoulder. Push the left fuel rail down until fuel injectors have bottomed
on injector shoulder.
7. Install the six fuel rail mounting bolts into the lower half of intake manifold. Tighten bolts to 15 Nm (136 in. lbs.) torque.
8. Connect electrical connectors at all fuel injectors. Push connector onto injector (1) and then push and lock red colored slider (2). Verify connector
is locked to injector by lightly tugging on connector. The injector wiring harness is numerically tagged.
9. Install upper half of intake manifold.
10. Connect main fuel line at fuel rail. Refer to Quick-Connect Fittings for procedures.
11. Install ignition coil pack and bracket assembly at intake manifold and right engine valve cover (four bolts).
12. Install throttle body to intake manifold. Refer to Throttle Body removal.
13. Install throttle body linkage to throttle body.
14. Install air cleaner tube and housing.
15. Install negative battery cable at battery.
16. Start engine and check for leaks.
