RAM 3500 Truck 2WD V8-5.7L (2008)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
RWAL Valve
Removal
REMOVAL
1. Disconnect the battery cables from the battery.
2. Remove the battery.
3. Disconnect the electrical harness connector.
4. Remove the brake lines from the RWAL valve (1).
5. Remove RWAL valve mounting nuts (2) and remove the RWAL valve (1).
Installation
INSTALLATION
1. Install RWAL valve (1) and Tighten the nuts (2) to 15 Nm (11 ft. lbs.).
2. Install the brake lines to the RWAL valve and tighten to 19 Nm (170 in. lbs.).
3. Install the electrical harness connector to the RWAL valve and secure the connector.
4. Install the battery.
5. Install the battery cables to the battery.
6. Bleed ABS brake system See: Brake Bleeding .