RAM 3500 Truck 2WD V8-5.7L (2008)
remove and discard the O-ring seals See: Heating and Air Conditioning/Coupler HVAC/Service and Repair/Removal .
20. Install plugs in, or tape over the opened ends of the A/C liquid lines and the evaporator tube.
21. Remove the rear section of the A/C liquid line from the engine compartment.
Suction Line
5.7L ENGINE
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Heating and Air
Conditioning/Service Precautions/Warning and See: Heating and Air Conditioning/Service Precautions/Caution. Failure to follow the
warnings and cautions could result in possible personal injury or death.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Recovery .
3. Remove the air filter housing.
4. Remove the nut (4) that secures the A/C suction line (5) to the A/C compressor (6).
5. Disconnect the A/C suction line from the A/C compressor and remove and discard the O-ring and gasket.
6. Install plugs in, or tape over the opened suction line fitting and the compressor port.
7. Remove the secondary retaining clip (7) from the spring-lock coupler (1) that secures the A/C suction line (6) to the A/C accumulator (5).
8. Using the proper A/C line disconnect tool (Special Tool Kit 7193 or equivalent), disconnect the A/C suction line from the A/C accumulator and
remove and discard the O-ring seals See: Heating and Air Conditioning/Coupler HVAC/Service and Repair/Removal .
9. Install plugs in, or tape over the opened suction line fitting and the accumulator tube.
10. Remove the A/C suction line from the engine compartment.
