RAM 3500 Truck 2WD V8-5.7L (2008)
7. Install electrical connector (3).
8. Install necessary vacuum lines.
9. Install air cleaner duct at throttle body.
10. Connect negative battery cable.
11. Using the diagnostic scan tool, erase all previous DTC's and perform the ETC Relearn function.
4.7L V-8
4.7L V-8
1. Check condition of throttle body-to-intake manifold O-ring. Replace as necessary.
2. Clean mating surfaces of throttle body and intake manifold.
3. Install throttle body-to-intake manifold O-ring.
4. Install all throttle body mounting bolts (1) finger tight.
CAUTION: The throttle body mounting bolts MUST be torqued to specifications. DO NOT OVER TIGHTEN MOUNTING BOLTS. Over
tightening can cause damage to the throttle body, throttle plate, gaskets, bolts and/or the intake manifold. Proper torque of the mounting bolts
is critical to normal operation.
5. Obtain a torque wrench. Tighten mounting bolts (as shown) in a mandatory torque criss-cross pattern sequence to 7.5 Nm (65 in. lbs.).
