RAM 3500 Truck 2WD V8-5.7L (2008)
REMOVAL
NOTE: If the Solenoid/Pressure Switch Assembly is being replaced, the Quick Learn Procedure must be performed. See: Testing and
Inspection/Programming and Relearning/Transmission Control Module/TCM Quick Learn
1. Raise vehicle on hoist.
2. Remove valve body assembly from transmission. See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Valve Body/Service and
Repair/Removal and Replacement/42RLE Automatic Transmission/Removal
3. Remove Solenoid/Pressure Switch Assembly retaining screws (2) from solenoid.
4. Remove Solenoid/Pressure Switch Assembly (1) and screen from valve body (2).
Installation
INSTALLATION
NOTE: If the Solenoid/Pressure Switch assembly is being replaced, the Quick Learn Procedure must be performed. See: Testing and
Inspection/Programming and Relearning/Transmission Control Module/TCM Quick Learn
1. Install Solenoid/Pressure Switch Assembly (1) and screen (3) to the separator and transfer plates.