RAM 3500 Truck 2WD V8-57L (2008) Transmission and Drivetrain Repair
4. Lower vehicle and connect the transmission range sensor (5) connector.
5. Connect solenoid/pressure switch assembly connector.
6. Connect the variable line pressure connector (4), if equipped.
7. Lower vehicle.
8. Fill transmission with ATF+4, Automatic Transmission Fluid. Verify proper fluid level. See: Service and Repair/Procedures/42RLE Automatic
Transmission/Transmission Fill - 42RLE
NOTE: If the valve body has been reconditioned or replaced, it is necessary to perform the Quick Learn Procedure.See: Transmission
Control Systems/Testing and Inspection/Programming and Relearning/Transmission Control Module See: Transmission Control
Systems/Testing and Inspection/Programming and Relearning/Transmission Control Module/TCM Quick Learn
Removal
REMOVAL
The valve body can be removed for service without having to remove the transmission assembly.
The valve body can be disassembled for cleaning and inspection of the individual components.
The only replaceable valve body components are:
-
Manual lever.
-
Manual lever washer, seal, E-clip, and shaft seal.
-
Manual lever detent ball.
-
Throttle lever.
-
Fluid filter.
-
Pressure adjusting screw bracket.
-
Governor pressure solenoid.
-
Governor pressure sensor (includes transmission temperature thermistor).
-
Converter clutch/overdrive solenoid assembly and harness.
-
Governor housing gasket.
-
Solenoid case connector O-rings.
1. Shift transmission into NEUTRAL.
2. Raise vehicle.
3. Remove gearshift and throttle levers from shaft of valve body manual lever.
