RAM 3500 Truck 2WD V8-5.7L (2008)
UPPER VALVE BODY HARNESS
NOTE: When installing the jumper harness, fix the harness portion that is protected with the clamp.
23. Install the jumper harness (5) into the clamp (4).
NOTE: Install the oil pressure switch connector (2) so that the orientation of the connector will be in a range of 0-90 degrees downward.
24. Connect the green wire of the jumper harness to the oil pressure switch (2).
NOTE: Install the oil pressure switch connector (3) so that the orientation of the connector will be in a range of 0-45 degrees downward.
25. Connect the orange wire of the jumper harness to the oil pressure switch (3).
Disassembly
DISASSEMBLY
NOTE: If the valve body is being reconditioned or replaced, it is necessary to perform the Quick Learn Procedure using the scan tool See:
Transmission Control Systems/Testing and Inspection/Programming and Relearning/Transmission Control Module/TCM Quick Learn