RAM 3500 Truck 2WD V8-5.7L VIN D (2003)
3. Place both camshaft sprocket and crankshaft sprocket on the bench with timing marks on exact imaginary center line through both camshaft and
crankshaft bores (Fig. 32).
CAUTION: The timing chain must be installed with the single plated link aligned with the dot and or paint marking on the camshaft sprocket.
The crankshaft sprocket is aligned with the dot and or paint marking on the sprocket between two plated timing chain links.
4. Place timing chain around both sprockets (Fig. 32).
5. Lift sprockets and chain (keep sprockets tight against the chain in position as shown).
6. Slide both sprockets evenly over their respective shafts and check alignment of timing marks.
7. Install the camshaft bolt. Tighten the bolt to 122 Nm (90 ft. lbs.) torque.
8. Remove tensioner pin. Again, verify alignment of timing marks.
9. Install the oil pump.
10. Install the oil pan and pick up.
11. Install the timing chain cover.
12. Fill cooling system.
14. Start engine and check for oil and coolant leaks.
