RAM 3500 Truck 2WD V8-5.7L VIN D (2003)
INSTALLATION
1. Install Accelerator Pedal Position Sensor (APPS) cable to accelerator pedal. Refer to Accelerator Pedal Removal/Installation.
2. Connect electrical connector to APPS.
3. If necessary, connect cable to APPS lever ball socket (snaps on).
4. Snap APPS cable cover closed.
5. Position APPS assembly to bottom of battery tray and install 3 bolts. Refer to Torque Specifications.
6. Install wheelhouse liner. Refer to Body.
7. Perform the following procedure:
a. Connect negative battery cable to battery.
b. Turn ignition switch ON, but do not crank engine.
c. Leave ignition switch ON for a minimum of 10 seconds. This will allow PCM to learn electrical parameters.
8. If the previous step is not performed, a Diagnostic Trouble Code (DTC) will be set.
9. If necessary, use DRB III Scan Tool to erase any Diagnostic Trouble Codes (DTC's) from PCM.
