dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

18-013-03 > < Engine Controls - MIL ON/Erroneous DTC's Set|Page 4154
Page 4
background image

a.

"DRBIII(R) Standalone"

b.

"1998 - 2004 Diagnostics"

c.

"All (Except Below)"

d.

"Engine"

e.

"Miscellaneous"

f.

"Check PCM Odometer

g.

"NO"

h.

Enter the current odometer mileage and then press "Enter".

I.

Cycle the ignition key to the OFF position and back to the ON position and then press "Enter".

NOTE:

Due to the PCM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKIM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate. Check all modules using "Module Scan", record the DTC's, and erase these DTC's
prior to returning the vehicle to the customer. Erase any DTC's in the PCM only after all other modules have had their DTC's erased.

NOTE:

The following step is required by law.

20.

Type the necessary information on the "Authorized Modification Label p/n 04275086AB and attach near the VECI label (Fig. 1).

POLICY:
Reimbursable within the provisions of the warranty.

TIME ALLOWANCE

FAILURE CODE

18-013-03 > < Engine Controls - MIL ON/Erroneous DTC's Set|Page 4154