RAM 3500 Truck 2WD V8-5.7L VIN D (2003)
c.
By contacting the District Manager.
CAUTION:
Failure to install the SKIM pin number into the module after flashing the PCM will cause a start and stall condition.
5.
Open the hood, install a battery charger and verify battery state is above 11.5 volts.
6.
If the old "PCM part #" is known, proceed to step 12. If the old "PCM part #" is not known, proceed to next step.
7.
On DealerCONNECT select the "Service" tab.
8.
Select "Vehicle Information Plus".
9.
Manually enter the VIN and mileage and select "Enter".
10.
Select the "Vehicle Option" tab.
11.
Under the "Vehicle Option" window, identify and record:
a.
Engine (sales code and description).
b.
Emissions (Federal or California)
c.
Transmission (Automatic, 5-speed manual, etc.).
12.
Connect the DRBIII(R) to TechCONNECT and the vehicle. Open TechTOOLS and verify that the "DRBIII(R) Status: Connected" message is in
the upper right corner of the TechTOOLS screen.
13.
TechTOOLS should automatically populate the VIN in the "Vehicle Criteria" area and the available updates. If not, manually enter the VIN then
TechTOOLS will populate the available updates.
14.
Determine the proper calibration:
a.
If the old "PCM part #" is known, enter the part number of the old controller in the 'Parts Criteria" p/n window. Proceed to step 15.
b.
If the old "PCM part #" is not known, select the correct calibration based on the information that was recorded from "Vehicle Options" in
step 11. Proceed to step 16.
15.
Select the correct calibration.
16.
Select the "Download/Update" button.
17.
Monitor the "Flash Download/Update Progress" window on the TechCONNECT and follow the instructions on TechCONNECT/DRBIII(R).
When the flash process is completed, proceed to next step.
18.
Enter the VIN in the PCM. Using the DRBIII(R) select:
a.
"DRBIII(R) Standalone"
b.
"1998 - 2004 Diagnostics"
c.
"All"
d.
"Engine"
e.
"Miscellaneous"
f.
"Check VIN"
g.
If the vehicle is not equipped with SKIM proceed to step 18h. If the vehicle is equipped with SKIM follow the directions on the DRBIII(R).
When the VIN and SKIM key has been programmed, proceed to step 19.
h.
Enter the VIN as requested by the DRBIII(R).
19.
Update the PCM mileage. Using the DRBIII(R) select:
