RAM 3500 Truck 2WD V8-5.7L VIN D (2003)
Washer Fluid Level Switch: Service and Repair
REMOVAL
The washer fluid level switch can be removed from the washer reservoir without removing the reservoir from the vehicle.
1. Unlatch and open the hood.
2. Disconnect and isolate the battery negative cable.
3. Disconnect the washer hose from the barbed outlet nipple of the washer pump/motor unit and allow the washer fluid to drain into a clean container
for reuse.
Fig.7 Washer Fluid Level Switch Remove/Install - Except V-10 & Diesel Engine
Fig.8 Washer Fluid Level Switch Remove/Install - V-10 & Diesel Engine
4. Disconnect the right (except V-10 and diesel engine) or left (V-10 and diesel engine only) headlamp and dash wire harness connector for the
washer fluid level switch from the switch connector receptacle.