RAM 3500 Truck 2WD V8-5.7L VIN D (2003)
Fig. 17
16. Using special tool slide hammer C-3752 with adapter 8990 remove the oil seal.
INSTALLATION
1. Inspect the piston teflon seals for damage. Replace if needed.
NOTE: To replace the teflon seals, use a pick to remove the teflon O-ring and the rubber O-ring underneath. Install a new rubber O-ring in the
piston seal grove and a new teflon O-ring over the top of it.
2. Install the valve into the valve housing.
Fig. 18
3. Thread the retainer ring into the valve housing. Tighten to 97 Nm (72 ft. lbs.).
NOTE: It is very important to make sure to compensate for the added length of the torque wrench when torquing to proper specifications.
4. Install the retainer ring set screw. Tighten to 2.26 Nm (20 in. lbs.).
5. Clean the steering gear housing.
