RAM 3500 Truck 2WD V8-5.7L VIN D (2003)
Tie Rod End: Testing and Inspection
Link/Coil
REMOVAL
Fig. 7
1. Remove tie rod nuts.
2. Remove tie rod from drag link and left knuckle with Puller C-4150A.
INSTALLATION
1. Install tie rod to the left steering knuckle and drag link. Install the nuts and tighten to 108 Nm (80 ft. lbs.).
2. Remove the supports and lower the vehicle to the surface. Center steering wheel and adjust toe.
3. After adjustment tighten tie rod adjustment sleeve clamp bolts to 61 Nm (45 ft. lbs.).
NOTE: Position the clamp on the sleeve so retaining bolt is located on the bottom side of the sleeve.
