RAM 3500 Truck 2WD V8-5.9L VIN 5 HDC (2000)
Cutting And Flaring Of Brake Fluid Tubing
8. Insert plug on gauge in the tube. Then swing compression disc over gauge and center tapered flaring screw in recess of compression disc.
9. Tighten tool handle until plug gauge is squarely seated on jaws of flaring tool. This will start the inverted flare.
10. Remove the plug gauge and complete the inverted flare.
IS0 FLARING
To make an ISO flare use Snap-On Flaring Tool TFM-428 or equivalent.
1. Cut off damaged tube with Tubing Cutter.
2. Remove any burrs from the inside of the tube.
3. Install tube nut on the tube.
4. Position the tube in the flaring tool flush with the top of the tool bar. Then tighten the tool bar on the tube.