RAM 3500 Truck 2WD V8-5.9L VIN Z LDC (1999)
Fig. 41
4. Remove retainer plate, governor body and gasket from transfer plate (Fig. 41).
5. Disconnect wires from governor pressure sensor, if not done previously.
Fig. 42
6. Remove governor pressure sensor from governor body. Sensor is retained in body with M-shaped spring clip (Fig. 42). Remove clip with small
pointed tool and slide sensor out of body.
Fig. 43
7. Remove governor pressure solenoid by pulling it straight out of bore in governor body (Fig. 43). Remove and discard solenoid O-rings if worn,
cut, or torn.
