RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN 6 (1998)
-
Step 3-Tighten the bolts, in sequence, an additional 90°.
5. Tighten the 8 mm bolts to 24 Nm (18 ft. lbs.) torque.
6. Install the valve cover. Tighten the valve cover bolt to 24 Nm (18 ft. lbs.) torque.
7. Install the EGR tube and start fasteners by hand.
8. Tighten all bolts/nuts to 24 Nm (212 inch lbs.) torque. When tightening bolts at EGR valve end of tube, alternate between the upper and lower
bolt to allow face of EGR valve to remain square to tube mounting flange on EGR tube.
