RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN 6 (1998)
Wheel Speed Sensor
10. Remove the wheel speed sensor from the hub bearing if equipped.
INSTALLATION
1. Install the wheel speed sensor in the hub bearing if equipped.
2. Position rotor on the hub/bearing.
Rotor, Hub/Bearing And Stud
3. Press wheel studs/hub extension studs through the back side of the rotor and through the hub bearing flange.
4. Apply liberal quantity of anti-seize compound to splines of front drive shaft.
5. Insert two rear-most, top and bottom rotor hub bolts in steering knuckle. Insert bolts through back side of knuckle so they extend out front face as
shown.
