RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Body Emblem: Service and Repair
EXTERIOR NAME PLATES
REMOVAL
NOTE: Exterior name plates are attached to body panels with adhesive tape.
1. Apply a length of masking tape on the body, parallel to the top edge and one end of the name plate to use as a guide for installation, if necessary.
2. If temperature is below 21 degrees C (70 degrees F) warm emblem with a heat lamp or gun. Do not exceed 52 degrees C (120 degrees F) when
heating name plate.
3. Using a trim stick C-4755 or equivalent, remove and discard the name plate.
INSTALLATION
1. Thoroughly clean all residue from the name plate attachment area of the body panel.
2. Wipe area with a clean lint free cloth moistened with a 50% solution of water and alcohol and wipe dry immediately with a dry lint free cloth.
3. Remove protective cover from adhesive tape on back of name plate.
4. Position name plate properly on the body panel.
5. Apply consistent and uniform pressure over the entire surface of the name plate, with palm of hand.
6. If temperature is below 21 degrees C (70 degrees F) warm emblem with a heat lamp or gun to assure adhesion. Do not exceed 52 degrees C (120
degrees F) when heating name plate.
