RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Brake Caliper: Service and Repair
Removal and Installation
Front
REMOVAL- FRONT
1. Raise and support vehicle.
2. Remove front wheel and tire assembly.
3. Remove caliper brake hose bolt, washers and hose.
4. Remove caliper mounting bolts.
5. Tilt the top of the caliper up and remove it from the adapter.
6. Remove anti-rattle springs.
NOTE: Upper and lower anti-rattle springs are not interchangeable.
Rear
REMOVAL- REAR
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Compress the disc brake caliper using tool #C4212F.
4. Remove the caliper pin bolts.
5. Remove the banjo bolt and discard the copper washer.
CAUTION: Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose with result. Provide a suitable support to
hang the caliper securely.
