RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
6. Remove the rear disc brake caliper.
Front
INSTALLATION- FRONT
1. Clean the caliper mounting adapter and the anti-rattle springs and grease with Mopar brake grease or Dow Corning 807 grease only.
2. Install the anti-rattle springs.
3. Tilt the bottom of the caliper over the rotor and under the adapter. Then push the top of the caliper down onto the adapter.
4. Install the caliper mounting bolts and tighten to 33 Nm (24 ft. lbs.).
5. Install the brake hose to caliper with new seal washers and tighten fitting bolt to 24 Nm (18 ft. lbs.).
CAUTION: Verify brake hose is not twisted or kinked before tightening fitting bolt.
6. Bleed the base brake system.
7. Install the wheel and tire assemblies.
8. Remove the supports and lower the vehicle.
9. Verify a firm pedal before moving the vehicle.
Rear
INSTALLATION- REAR
NOTE: Install a new copper washers on the banjo bolt when installing
1. Install the rear disc brake caliper.
2. Install the banjo bolt with new copper washers to the caliper. Tighten to 38 Nm (28 ft. lbs.)
3. Install the caliper pin bolts. tighten to 33 Nm (25 ft. lbs.)
