RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
8. Remove the mounting nuts from the hydraulic booster and remove the booster.
INSTALLATION
1. Install the hydraulic booster and tighten the mounting nuts to 28 Nm (21 ft. lbs.).
2. Install the booster push rod, washer and clip onto the brake pedal.
3. Install the master cylinder on the mounting studs. and tighten the mounting nuts to 23 Nm (17 ft. lbs.).
4. Install the brake lines to the master cylinder and tighten to 19 - 200 Nm (170 - 200 inch lbs.).
5. Install the hydraulic booster line bracket onto the master cylinder mounting studs.
6. Install the master cylinder mounting nuts and tighten to 23 Nm (17 ft. lbs.).
7. Install the hydraulic booster pressure lines to the bracket and booster.
8. Tighten the pressure lines to 41 Nm (30 ft. lbs.).
NOTE: Inspect O-rings on the pressure line fittings to insure they are in good condition before installation. Replace O-rings if necessary.
9. Install the return hose to the booster.
10. Bleed base brake system.
11. Fill the power steering pump with fluid.
CAUTION: Use only MOPAR power steering fluid or equivalent. Do not use automatic transmission fluid and do not overfill.
12. Bleed the hydraulic booster.
