RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
3. Retrieve the tappet installation tool using the hooked rod provided with the tool kit (Fig. 120).
4. Lubricate the tappet with clean engine oil or suitable equivalent and install the tappet to the installation tool (Fig. 121).
5. Pull the tappet up and into position (Fig. 121). If difficulty is experienced getting the tappet to make the turn into the tappet bore, wiggle the
trough while gently pulling up on the tappet.
6. With the tappet in place, rotate the trough one half turn so the open side is down (toward crankshaft) (Fig. 122).
7. Remove the tappet installation tool from the tappet.
8. Re-install a dowel rod and secure the rod with a rubber band.
9. Rotate the trough one half turn and repeat the procedure for the remaining tappets.
10. Install the camshaft.
