RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
13.
Remove the tappet cover mounting bolts and side cover.
14.
Install new tappet cover with breather tube. Torque bolts to 24 N.m (17 ft.lbs.)
NOTE:
BREATHER TUBE SHOULD BE ROUTED DOWN, BEHIND THE STARTER AND AWAY FROM THE DIFFERENTIAL.
15.
Reconnect and install fuel line "T" fitting and mounting bracket.
16.
Install the mounting bolt that secures the fuel line to the tappet cover.
17.
Install the engine controller.
18.
Install the fuel pump. (Section 14)
19.
Install the fuel filter/water separator assembly. (Section 14)
20.
Install the replacement access plug on the front of the gear cover.
21.
Install the fan shroud and viscous fan. (Section 7)
22.
Install the washer bottle.
23.
Install the charge air cooler duct.
24.
Install the air intake connector.
25.
Reconnect both negative battery cables.
26.
Start the engine and check for leaks.
27.
Close the hood and reprogram the radio (if necessary).
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE
FAILURE CODE
