RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Engine Mount: Service and Repair
Front Mount
REMOVAL
1. Disconnect the battery negative cables.
2. Remove the viscous fan/drive assembly.
3. Raise vehicle on hoist.
4. Support engine with a screw jack and wood block.
5. Loosen the thru-bolt and nut (Fig. 145).
6. Passenger side mount: Remove the two 2 transmission oil cooler bracket to engine mount bolts.
7. Lift the engine SLIGHTLY and remove the four 4 mount to block bolts.
8. Remove the mount from the vehicle.
INSTALLATION
1. With engine raised SLIGHTLY, position the engine mount to the block. Install the bolts and tighten to 149 Nm (110 ft. lbs.) torque.
2. Install the thru-bolt into the engine mount.
3. Lower the engine while guiding the mount and thru-bolt into the frame mounted support cushion brackets (Fig. 146).
4. Install the thru-bolt nut and tighten the nut to 88 Nm (65 ft. lbs.) torque.
5. Passenger side: Install the two 2 transmission oil cooler bracket to mount bolts. Tighten the bolts to 47 Nm (35 ft. lbs.) torque.
6. Remove lifting fixture.
7. Lower the vehicle.
8. Install the viscous fan/drive assembly.
9. Connect the battery negative cables.