RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
10. Gently, remove the steering pump from the adapter. Use caution not to damage the oil seal in the adapter body (Fig. 28).
INSTALLATION
NOTE: Make sure the two pump spacers are present before assembling power steering pump to adapter.
1. Aline the steering pump drive dog with the slot in the vacuum pump drive assembly, slide the steering pump into place on the adapter.Use care not
to damage the oil seal in the adapter body
2. Install the three steering pump to adapter nuts, do not install the lower inboard mounting nut at this time. Tighten nuts to 24 Nm (18 ft. lbs.).
3. Position new gasket on vacuum pump mounting flange (Fig. 29). Use Mopar Perfect Seal, or silicone adhesive/sealer to hold gasket in place.
4. Insert pump assembly upper attaching bolt in mounting flange and gasket. Use sealer or grease to hold bolt in place if necessary.
