RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Blower Motor: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
Fig. 3 Blower Motor Remove/Install
2. Disconnect the blower motor cooling tube from the nipple on the blower motor housing.
3. Disengage the blower motor wire harness from the wire harness retainer.
4. Unplug the blower motor wire harness connector from the HVAC housing wire harness.
5. Remove the three screws that secure the blower motor and blower wheel assembly to the HVAC housing.
6. Lower the blower motor and wheel assembly and cover, from the HVAC housing.
Fig. 4 Blower Motor Wheel Remove/Install
7. Remove the blower wheel retainer clip and remove the wheel from the blower motor shaft.
INSTALLATION
1. If installing the blower motor wheel only, press the blower wheel hub onto the blower motor shaft. Be sure the flat on the blower motor shaft is
indexed to the flat on the inside of the blower wheel hub.
2. Install the retainer clip over the blower wheel hub. The ears of the retainer clip must be indexed over the flats on the blower motor shaft and
